No.

Description

1

Factory Settings becomes an independent tab in Configuration > Settings > AP > Initial Conifg Template > Modify page.

No.

Description

1

The Web kept freezing occasionally when over ten thousand network groups were created or over ten thousand devices were imported.

No.

Module

Description

1

Device

Up to 200 devices can be imported each time. To import more than 300 devices, users need to do it in batches.

2

Configuration

Configurations of up to 200 devices can be imported each time. To import configurations of over 200 devices, users need to do it in batches.

3

EXCEL template

For Excel template, only the XLS format is supported.

4

SSID

SSIDs can be made up of numbers, English letters, and “-“.

5

Custom excel template

In an Excel customized template, A to Z columns and 1 to 15 rows are supported.

6

AP

Account-based policies may fail on some models, such as AP680(CD), where they are disabled by default. In this case, users need to batch apply from the Cloud the web-auth acct-update-interval 1 command to enable those policies.

7

SSID reverse sync

The Cloud does not support SSIDs containing special characters. If set on end devices, such SSIDs will fail to be delivered, after synchronization, by the Could.

8

00000JAPAN Wi-Fi

In the Apartment Scenario, if the device goes offline after 00000JAPAN Wi-Fi is enabled, and then goes online after 00000JAPAN Wi-Fi disabled, Cloud will not re-configure the Wi-Fi settings on device. You need to clear 00000JAPAN Wi-Fi configuration manually.

9

AP

In Non-apartment Scenario, please clear the configuration on devices except

AP180 before bring them online; otherwise, the configuration on devices may be conflict with that on Cloud, and the client may not be able to access the Internet.

10

AP

In Non-apartment Scenario, if the working mode (bridge mode or routing mode) of AP180 is different from that on Cloud, the client may not be able to access the Internet.

11

TOPOLOGY

1. Only devices connected to the downlink port of the switch can be detected.

2. Only EG5210-JP, XS-1930J series switches and APs can be displayed in the topology.

3. Only the devices in the same network and subnetwork can be displayed in the topology.

4. DHCP Diagnosis: only supports dynamic IP; the IP address of device can be recognized correctly only after four hours when its address pool range is changed.

5. When the downlink devices of EG5210-JP are offline, they still can be displayed in the topology for 1 hour, but the traffic information of interfaces cannot be displayed. 

6. Loop detection is not supported.

12

TOPOLOGY

The uplink ports of some switches cannot be shielded in the topology as the Cloud fails to identify them.

Included:

XS-S1930J-8GT2SFP, XS-S1930J-8GT2SFP-P

XS-S1930J-18GT2SFP, XS-S1930J-18GT2SFP-P

XS-S1930J-24GT4SFP/2GT, XS-S1930J-24GT4SFP/2GT-P

XS-S1930J-48GT4SFP

13

Initial Configuration Template

The template can only be applied to AP180 series access points in Apartment networks.

14

CLI Commands

15

WPA3-SAE

16

Device Details-Back Up

17

Network Management

18

Upgrade Policy

1. Not supported in sub accounts and networks shared by another networks.

2. Only for MA and AP180 series access points.

3. Only one upgrade policy can be configured for a device model.

19

Quick Deployment

1. This feature is applicable only to AP180 series access points.

2. Switches only can detect the APs that can access wide area networks.